Adjustment Of The Collector Channel Guide - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=

ADJUSTMENT OF THE COLLECTOR CHANNEL GUIDE

4.11 ADJUSTMENT OF THE COLLECTOR
CHANNEL GUIDE
This adjustment is to be made after any work on
the collector channel guide and if the rear plate
has been dismantled.
The importance of this adjustment is in avoiding
that incorrectly inserting the channel opening in
the hole in the plate prevents the wheels cover
[see 2.5] from closing properly which could let
grass cuttings get into the engine housing causing
damage.
u Fit the channel [see 5.5].
Take the cutting deck to position «1». In this condi-
tion, the channel (1) should be properly sitting in the
guide (2).
If the guide is lower or tends to raise the channel
too much, loosen the screw (3) and make the guide
slide until it is repositioned correctly.
Always check that, when the wheels cover is closed
according to the regular procedure [see 2.5], the
channel always inserts in the hole of the plate regu-
larly and automatically, and with no need to help it
in manually.
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
4.11.
1
3
~ 3 mm
3
2
72
1999
••••
from to
1 / 1
page
2 1
4/2005