Global garden products 72 Serie Kundendienst Handbuch Seite 116

<= ...BACK... <=
5.7a.
4
screw with nut (32) and is fixed to the chassis by
four screws with relative nuts (33).
Unscrew nut (32), then carefully unscrew the nuts
(33) of the four lower screws, suitably supporting
the group so it cannot fall and taking account of the
weight of approximately 20 - 22 kg.
Carry out the above operations in reverse to
reassemble.
NOTE
When the transmission release control rod (29) is
reconnected, the bevel fastener (30) must always
be replaced since it is damaged during dismantling
u [see 2.6.C].
Check that the spacers (35 – 37– 37) are correctly
fitted to the shafts, in the sequence given.
Reattach all the connections, and then ...
u Check the brake [see 4.3]
u Refit the engine pulley [see 5.5] to release the
belt.
u Refit the rear wheels [see 6.1].
u Lift the wheels cover [see 2.5].
If the control rod has been replaced or completely
dismantled...
u Adjust the travel and the position of "neutral" for
the lever [see 4.5.A].
Tightening torques
25 Brake pin fastening nut .................. 25 ÷ 30 Nm
32 Rear axle support nut ..................... 25 ÷ 30 Nm
33 Rear axle fastening nuts ................. 25 ÷ 30 Nm
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
- REMOVAL OF THE REAR AXLE
(Tuff Torq K46T)
2006
from
page
29
30
31
32
35 36 37
72
••••
to
2 / 2
4/2007