Herunterladen Inhalt Inhalt Diese Seite drucken

Global garden products 72 Serie Kundendienst Handbuch Seite 112

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

<= ...BACK... <=
WORKSHOP MANUAL
72
2004
••••
5.6.
from
to
1
REMOVAL OF THE ENGINE
2 / 2
page
When reassembling, fully tighten the screws for the engine and the pulley to the amounts shown.
Remember to fit the clamp back on the fuel pipe and check that it does not leak.
Reattach all the electrical and earth contacts and refit the protection covers (5).
➤ For hydrostatic drive models: refit the spring (1) of the stretcher.
Reattach the accelerator cable and ...
u Adjust the «MINIMUM» position [see 6.7].
u Close up the wheels cover [ see 2.5].
Tightening torque
1 Screw for engine pulley. ................... 45 ÷ 50 Nm
– Screws for engine fastening ............. 25 ÷ 30 Nm
© by GLOBAL GARDEN PRODUCTS
4/2005

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

72 hydro

Inhaltsverzeichnis