Removal Of The Rear Plate - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=

REMOVAL OF THE REAR PLATE

5.4 REMOVAL OF THE REAR PLATE
The rear plate does not need to be removed for
access to other parts for work. The following pro-
cedure is only for replacing with a new one.
u Remove the wheels cover [see 5.3].
Close up the frame of the cover, tightening the fix-
ing nut (1).
Detach the electrical connections from the "grass-
catcher attached" microswitch (2) and the "grass-
catcher full" microswitch (3) and release the stop
cable (4).
The plate is hinged at the base of the machine's
frame by two small plates (5), each of which is fixed
by four screws (6), and is attached to the frame of
the wheels cover by four screws (7).
First of all, undo the four upper screws (7) and then
dismantle the two lower plates (5), ensuring that the
wheels cover frame has the necessary stability
since, by removing the plate, it is without support at
the back.
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
5.4.
1
4
from
page
1
2
3
5
72
2001
••••
to
1 / 2
6
4/2005