Removal Of The Rear Axle (Tuff Torq K46T) - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=
5.7a.
4
5.7a REMOVAL OF THE REAR AXLE
(Tuff Torq K46T)
The rear axle (Transaxle) is made up of single
maintenance-free sealed unit which includes the
transmission unit (hydrostatic) and the differential.
It only needs to be removed to be replaced or for
an overhaul by the Manufacturer's Service Centre.
u Lift the wheels cover [see 2.5].
u Dismantle the engine pulley [see 5.5] to release
the belt.
Place two spacers (1) of approximately 150 mm
under the two ends of the rear plate.
u Remove the rear wheels [see 6.1].
Disconnect the drive control rod (21) by removing
the split pin (22), remove the pin (23) from the brake
rod (24) unscrewing nut (25); move the tensioner
guide pulley (26) to the right and free the pulley (27)
from the belt (28).
Disconnect the transmission release control rod
(29), held by a bevel fastener (30).
The group is supported by a support (31) fixed by a
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
- REMOVAL OF THE REAR AXLE
(Tuff Torq K46T)
23 24
25
from
page
1
22 21
27
28
27
28
31
32
72
2006
••••
to
1 / 2
26
4/2007