Check On Blade Alignment - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=

CHECK ON BLADE ALIGNMENT

4.9 CHECK ON BLADE ALIGNMENT
Excessive vibration when cutting and an uneven
cut can be due to misalignment of the blade
owing to deformation of the flange or the shaft as
a result of accidental knocks.
u Place the machine on its side [see 2.4].
Always wear strong gloves when handling the
blade.
Disengage the blade, place a straight metal rod (1)
on a point around the edge of the deck (2), turn the
blade by hand and check the distance between the
rod and the two ends "A" and "B". The distance
should be the same, and any difference should not
exceed 2 - 3 mm.
If higher amounts are found, check that the blade is
not distorted. If this is not the case, check the sup-
port or the shaft for the blade [see 6.6], replacing if
necessary, and check the condition of the point
where the flange rests on the cutting deck.
IMPORTANT!
Always replace a damaged blade and do not
attempt to repair or straighten it. Always use
manufacturer's genuine spare parts!
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
4.9.
0
from
page
2 1
2
1
A
72
1998
••••
to
1 / 1
B
3/2002