Global garden products 72 Serie Kundendienst Handbuch Seite 118

<= ...BACK... <=
5.7b.
3
depending on the type used – with their screws (19)
and (20) and is fastened to the frame (16) by four
screws (17).
Loosen the screw(s) (20) to permit a minimum of
movement of the bracket(s) (18) and undo the
screw(s) (19). Then carefully undo the four lower
screws (17), giving sufficient support to the unit so
that it does not fall, bearing in mind its weight of
around 15 - 22 kg.
Reassemble in the reverse order, being particularly
careful with the two self-tapping screws (19) which,
if not screwed in correctly, can damage the internal
thread preventing correct fastening.
NOTE
When tightening the screw (20) on the left-hand
side, be careful with the stop cable (22), which must
always be taut and straight when the cover is open.
Check that the spacers (23) are correctly fitted to
the shafts.
Reattach all the connections, and then ...
u Check the brake [see 4.3]
u Refit the engine pulley [see 5.5] to release the
belt.
u Refit the rear wheels [see 6.1].
u Lift the wheels cover [see 2.5].
If the control rod has been replaced or completely
dismantled...
u Adjust the travel and the position of "neutral" for
the lever [see 4.5.A].
Tightening torques
17 Screws for rear axle fastening ........ 25 ÷ 30 Nm
19 Self-tapping screws ....................... 25 ÷ 30 Nm
20 Screws for brackets ....................... 25 ÷ 30 Nm
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
- REMOVAL OF THE REAR AXLE
(Peerless LTH 2000-004C)
14
15
11
20
12
11
17
23
72
2004
••••
from to
2 / 2
page
22
16
20
18
19
4/2007