Replacement Of The Drive Belt - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <=

REPLACEMENT OF THE DRIVE BELT

6.4 REPLACEMENT OF THE DRIVE BELT
u Dismantle the engine pulley [see 5.6] to release
the belt.
u Lift the wheels cover [see 2.5].
It also helps if the transmission belt is loosened.
This is done by ...
➤ In mechanical drive models: engaging the
parking brake
➤ In hydrostatic drive models: releasing the
spring (1) of the stretcher
Dismantle the pulley of the stretcher (2), held by the
nut (3).
➤ Mechanical drive models:
Remove the snap ring (4) and lift the pulley (5)
just enough to free the belt (6).
At this point the belt can be removed.
On reassembling, make sure that the belt (6) is cor-
rectly positioned in the pulleys inside the rims [see
8.2.4].
When assembly is completed ...
u Close the wheels cover [see 2.5].
u Refit the engine pulley [see 5.6].
➤ Mechanical drive models:
u Adjust the drive engagement [see 4.5].
Tightening torque
3 Pulley fixing nut ................................ 25 ÷ 30 Nm
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
6.4.
0
1
6
3 2
4
72
1998
••••
from to
1 / 1
page
5
6
3/2002