Global garden products 72 Serie Kundendienst Handbuch Seite 113

<= ...BACK... <=
5.7.
4
(Peerless MST 205-541 E - Dana 4360-210)
5.7 REMOVAL OF THE REAR AXLE
(Peerless MST 205-541 E - Dana 4360-210)
The rear axle (Transaxle) is made up of single
maintenance-free sealed unit which includes the
transmission unit (mechanical) and the differential.
It only needs to be removed to be replaced or for
an overhaul by the Manufacturer's Service Centre.
u Lift the wheels cover [see 2.5].
u Dismantle the engine pulley [see 5.5] to release
the belt.
Place two spacers (1) of approximately 150 mm
under the two ends of the rear plate.
u Remove the rear wheels [see 6.1].
Engage the parking brake to slacken off the trans-
mission belt and remove the pin (2) from the brake
rod (3).
Disconnect the control rod (4) of the gear-change
by taking out the split pin (5), and disconnect the
wires of the microswitch (6) for signalling the "neu-
tral" position.
Also dismantle the pulley (7) held by a snap ring (8).
The unit is supported by two brackets (9) – depend-
ing on the type used – with their screws (10) and
(11) and is fastened to the frame (12) by four screws
(13).
Loosen the screws (11) to permit a minimum of
movement of the brackets (9) and undo the screws
(10). Then carefully undo the four lower screws (13),
giving sufficient support to the unit so that it does
not fall, bearing in mind its weight of around 15 - 22
kg.
Reassemble in the reverse order, being particularly
careful with the two self-tapping screws (10) which,
if not screwed in correctly, can damage the internal
thread preventing correct fastening.
© by GLOBAL GARDEN PRODUCTS
WORKSHOP MANUAL
- REMOVAL OF THE REAR AXLE
from
page
1
3 2
8 7
12
13
72
2006
••••
to
1 / 2
5
4
6
14
11
9
10
4/2007