Replacement Of The Accelerator - Global garden products 72 Serie Kundendienst Handbuch

<= ...BACK... <= WORKSHOP MANUAL
72
1998
••••
6.7.
from to
0

REPLACEMENT OF THE ACCELERATOR

1 / 1
page
6.7 REPLACEMENT OF THE ACCELERATOR
Take the small knob (1) off the accelerator.
u Lift the wheels cover [see 2.5].
1
Disconnect the end of the cable (2) from the cou-
pling terminal (3) on the engine.
Remove the clamp (4), undo the two screws (5) and
take out the accelerator together with the cable.
On reassembling, put the accelerator lever in the
6 3
«MINIMUM» position shown on the label, connect
the end of the wire (2) to the terminal (3) on the
engine after having moved the cursor (6) in the
same «MINIMUM» position specific to each type of
2
engine and shown in the instruction handbook.
Lastly, put back the clamp (4) and ...
u Close up the wheels cover [see 2.5].
5
4
© by GLOBAL GARDEN PRODUCTS 3/2002