Eliwell ICPlus 915 Bedienungsanleitung Seite 24

The Copy Card is connected to the serial port (TTL) and allows rapid programming of the instrument parameters.
Access Installer parameters by entering PA2, scroll through the folders using
it using , scroll through the parameters using
• Upload (UL): Select UL and press
card. If the procedure is a success, y, will appear on the display, otherwise n will appear.
• Format (Fr):
This command is used to format the Copy Card (recommended when using the card for the first time).
Note: the Fr parameter deletes all data present. This operation cannot be cancelled.
• Download (dL): Connect the Copy Card when the instrument is switched off. At power-on, data is downloaded from the copy
card to the instrument automatically. At the end of the lamp test, the display will show dLy if the operation
was successful and dLn if not.
NOTE: After downloading, the instrument works with the settings of the new map just downloaded.
D.I. FROM KEY OR FROM MENU
H13
ENABLED
STATE
NO open YES
NO closed YES
NC open YES
NC closed YES
NOP open YES
NOP closed NO
NCP open YES
NCP closed N/A
USING THE COPY CARD
and
. This function uploads the programming parameters from the instrument to the
H13 PARAMETER CONFIGURATION
FUNCTION
DISABLED
STATE
YES
YES
YES
YES
YES
N/A
YES
NO
24
and
, then select the function using
COMMENTS
ON enabled / disabled with each mode
OFF enabled / disabled with each mode
OFF enabled / disabled with each mode
ON enabled / disabled with each mode
ON enabled only from D.I. / disabled with each mode
OFF Enabled only when D.I. is reopened
OFF enabled with each mode / disabled only from D.I.
ON enabled with each mode / disabled only from D.I.
until folder FPr appears. Select
(UL).