Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Access the Machine Status menu by pressing
Use the keys
and
Setting the
To display the Setpoint value press the
Setpoint:
The Setpoint value appears on the display. To change the Setpoint value, press the
within 15 seconds. Press
Displaying
When label Pb1 is present, press the
(NOTE: the value cannot be modified).
probes:
o access the Programming menu, press the
T
requested: PA1 for User parameters and PA2 for Installer parameters (see PASSWORD paragraph).
User Parameter:
When accessed, the display will show the first parameter (dF1). Press
all the parameters on the current level. Select the desired parameter by pressing
Installer Parameter: When accessed, the display will show the first folder (rE1). Press
folders on the current level. Select the desired folder using
parameters in the current folder and select the parameter using
NOTE: The instrument must be switched off and then on again each time the configuration of the parameters is changed.
'MACHINE STATUS' MENU
and releasing the key. If no alarms are active, the SP1 label appears.
to scroll through all the folders in the menu:
to confirm the modification.
'PROGRAMMING' MENU
to modify it and
to save the changes.
to save the changes.
- AL:
alarms folder (only visible if an alarm is active);
- SP1: Setpoint 1 setting folder;
- SP2: Setpoint 2 setting folder;
- Pb1: probe 1 - Pb1 folder.
key when the SP1 or SP2 label is displayed.
key to view the value measured by the corresponding probe
key for more than 5 seconds. If specified, an access PASSWORD will be
17
and
to scroll through
. Press
and
to scroll through the
. Press
and
to scroll through the
. Press
and
to modify it and
and
keys
and
Werbung
Inhaltsverzeichnis
