Symbols Used In This Document; Scope Of Delivery - Grundfos Multilift MOG Installations- Und Bedienungsanleitung

English (GB) Installation and operating instructions
Original installation and operating instructions.
TABLE OF CONTENTS
1.

Symbols used in this document

2.

Scope of delivery

3. General description
3.1 Applications
4. Transportation and storage
5. Product description
5.1 Lifting station
5.2 LC 221 controller
6. Operating LC 221 controller
6.1 Description of display
6.2 Setup menu
6.3 Information menu
6.4 Description of fault indications
7. Installation of lifting station
7.1 General description
7.2 Guidelines for installation of lifting station
7.3 Procedure for installation of lifting station
8. Installation of LC 221 controller
8.1 Location
8.2 Mechanical installation
8.3 Electrical connection
8.4 Setting of LC 221
8.5 Wiring diagrams
9. Startup
10. Maintenance and service
10.1 Mechanical maintenance
10.2 Electrical maintenance
10.3 Cleaning the level sensor
10.4 Contaminated lifting station or components
11. Fault finding
12. Technical data
12.1 Lifting station
12.2 Collecting tank
12.3 Pump
12.4 LC 221 controller
12.5 Performance curves
13. Disposal
Warning
Prior to installation, read these installation and
operating instructions. Installation and operation
must comply with local regulations and accepted
codes of good practice.
1. Symbols used in this document
Warning
Page If these safety instructions are not observed,
it may result in personal injury.
5
5
Warning
6
These instructions must be observed for
7
explosion-proof pumps. We recommend that you
7
also follow these instructions for standard
7 pumps.
7
If these safety instructions are not observed,
10
Caution
it may result in malfunction or damage to the
14
equipment.
14
16
Notes or instructions that make the job easier
Note
17
and ensure safe operation.
18
20
2. Scope of delivery
20
Grundfos Multilift MOG (one pump) and MDG (two pumps) lifting
21
stations are supplied complete with collecting tank, a sensor unit
22
with cable and one or two pumps with cable, connected to the
23
LC 221 controller. The controller includes a power supply cable
23
with plug.
24
An accessories bag containing the following items is also
24
included:
24
• 1 x installation and operating instructions
25
• 1 x Quick guide for controller menu
26
• 1 x oval discharge flange, 1 1/4" (MOG)
26
2 x oval discharge flanges, 1 1/4" (MDG)
27
• 1 x flexible hose, DN 70, and two clamps to connect venting
27
pipe
27
27 • 2 x screw and expansion anchor for tank fixation
• 3 x screw and washer for fastening a pipe plug in the inlet disk,
28
if required
29
• 1 x socket seal, DN 100
29
29
• 1 x socket seal, DN 50, for diaphragm pump connection or
29
inlet, DN 50.
29
The lifting stations are supplied complete with one or two pumps
31
and a controller.
31
Lifting station
MOG, one-pump lifting station
MDG, two-pump lifting station
Controller
LC 221.1
LC 221.2
5