Footrests - Otto Bock C2000 Gebrauchsanweisung

Operation
Fig. 12 Adapting the control panel
INFORMATION
If the control panel rail is too long, the protruding part can
be cut off with a saw.
138 Ottobock
|
Changing the Control Panel's Mounting Side
INFORMATION
Only authorised personnel may change the control panel's
mounting side.
The standard configuration has the control panel mounted
on the right side. If desired by the user, it can also be
mounted on the other side of the power wheelchair.

6.1.4 Footrests

CAUTION
Risk of pinching!
Make sure your fingers are not in the danger area when
folding the footplate(s) up or down.
The C2000 can be equipped either with a narrow or wide
single-panel footrest or with two individual footrests. They
are mounted to the C2000 power wheelchair with a receiver
attached to rails that are already adapted in their length to
the user. For the C2000 power wheelchair version with rear-
wheel drive, only the narrow footplate is available. All foot-
rest versions can be folded up.
C2000