Settings; Initial Operation - Otto Bock C2000 Gebrauchsanweisung

Delivery and Preparation for Use
4.2

Settings

The following tools are required to adjust the wheelchair to
the requirements of the user and for maintenance work:
n Allen wrenches, sizes 3 to 6
n Open-end or combination wrenches, sizes 8, 10, 13
n Phillips screwdriver
n Screwdriver for pan head screws
n Tyre repair accessories
4.3

Initial Operation

WARNING
Risk of suffocation. Packaging materials must be kept out
of reach of children.
All components must be checked for completeness and
functionality prior to initial operation. Before the C2000
power wheelchair can be switched on, the 120 A fuse must
be inserted into the fuse holder (see Fig. 3). The fuse holder
is located laterally on the drive unit sustainer, next to the
charging receptacle.
130 Ottobock
|
To do so, remove the fuse from the protective cover on the
control panel, open the cap of the fuse housing and insert
the fuse.
Make sure that the fuse is pressed into the centre of the
spring contacts and that it is not at an angle.
2
Fig. 3 Fuse housing with inserted fuse
1 Fuse housing with open cap
2 Fuse
1
C2000