Steering Lock - Otto Bock C2000 Gebrauchsanweisung

Operation
Deactivation via separate LCD monitor
After switching the power wheelchair on, an information win-
dow appears on the LCD monitor. Deactivation is similar to
"Deactivation via control panel".

6.3.7 Steering Lock

INFORMATION
The steering lock can be activated in the manner described
below if the "Steering Lock" parameter is set to "On". The
steering lock parameter is set to "Off" by default. The fac-
tory setting may also have been set to "On" by the special-
ist dealer or at the factory according to the order. Please
ask your specialist dealer about the setting selected for
your wheelchair.
The enAble50 control unit in the power wheelchair may be
programmed with the optional "Steering Lock" parameter.
If the steering lock is activated, the caster wheels or the
drive wheels (depending on the type) are set straight ahead.
This makes it easier to negotiate narrow ramps and to use
elevators.
n When the joystick is deflected forward, the power
wheelchair drives straight ahead.
150 Ottobock
|
n When the joystick is deflected backward, the power
wheelchair drives straight back.
n Turning is not possible when the steering lock is acti-
vated.
n The warning flasher lights flash when the steering lock
is activated (standard programming).
Activating the Steering Lock
1. Bring the power wheelchair to a full stop.
2. Push the [Warning Flasher] button.The steering lock is
activated. All warning flasher lights flash (standard pro-
gramming).
3. Move the joystick forward/backward. The power wheel-
chair only drives straight ahead or back.
Deactivating the Steering Lock
1. Bring the power wheelchair to a full stop.
2. Push the [Warning Flasher] button. The steering lock is
deactivated. All warning flasher lights stop flashing.
3. Move the joystick. The power wheelchair now drives in
the chosen direction without steering lock.
C2000