From The Front; Figure 13 Footplates Flipped Up; Figure 14 Footrests Swung To The Side - Otto Bock B600 Bedienungsanleitung

Operation
where the user will get into the wheelchair. Bring the power
wheelchair as close as possible to the place where its user
is sitting.
If the control panel is located on the side where the user is
getting in or out, carefully remove the control panel. Remove
the side panel as described in Section 6.1.3 (remove the
footrest if necessary; see Section 6.1.5).
The user can then slide onto the wheelchair seat from the
side. Use of a transfer board will make this even easier.

6.2.2 From the Front

Flipping up the two footplates makes it possible for the user
to get into and out of the wheelchair from the front (Fig-
ure 13). Swinging the footrests away to the sides increases
the amount of space available when getting in or out (Fig-
ure 14). If required, it is also possible to remove the footrests
from their adapter after swinging them out of the way (Fig-
ure 15; please observe the safety information in Section
6.1.5, footrest).
The assistance of an attendant or a transfer lifter allows the
user to get into or out of the power wheelchair easily. Use of
a rotation plate is also possible.
Page 120
Downloaded from www.Manualslib.com manuals search engine
Figure 13 Footplates flipped up
Figure 14 Footrests swung to the side
02/2009 B600