Preparing The Machine For Repair, Maintenance And Adjustment Work; Starting The Machine Safely - Krone Swadro TC 760 Bedienungsanleitung

Pos: 17.11.12 /Überschriften/Überschriften 3/K-O/Maschine für Instandhaltungs-, Reparatur-, Wartungs- und Einstellarbeiten vorbereiten @ 274\mod_1404283183227_78.docx @ 2062418 @ 3 @ 1
4.5.5

Preparing the machine for repair, maintenance and adjustment work

Pos: 17.11.13 /BA/Sicherheit/3. Sicherheitsroutinen/Maschine für Instandhaltungs-, Reparatur-, Wartungs- und Einstellarbeiten vorbereiten @ 272\mod_1403522290336_78.docx @ 2051115 @ @ 1
WARNING!
Risk of injury during repair, maintenance and adjustment work on the machine.
If the machine has not been shut down, the machine or machine parts may move
unintentionally. As a result, people may be seriously injured or killed.
If the machine is not supported securely, the machine or machine parts may roll, fall or drop. As
a result, people may be seriously injured or killed.
• Before starting repair, maintenance and adjustment work, perform the following steps:
• Shut down and safeguard the machine, see chapter Safety, "Shutting down and
safeguarding the machine".
• The raised machine or machine parts must be securely supported, see chapter Safety
"Securely supporting the raised machine and machine parts".
Pos: 17.11.14 /Überschriften/Überschriften 3/K-O/Maschine sicher in Betrieb nehmen @ 274\mod_1404282899544_78.docx @ 2062230 @ 3 @ 1
4.5.6

Starting the machine safely

Pos: 17.11.15 /BA/Sicherheit/3. Sicherheitsroutinen/Maschine sicher in Betrieb nehmen - 540 1/min, ohne Elektronik, ohne Bremsen @ 277\mod_1404821879635_78.docx @ 2078965 @ @ 1
WARNING!
Risk of injury while starting up the machine
If the machine has not been safely placed in operation, the machine or machine parts may
move unintentionally. As a result, people may be seriously injured or killed.
• Make certain before starting up the machine that the following requirements are met:
– The hydraulic lines are connected.
– The universal shaft is connected and secured.
– The lighting system is connected.
– The safety chain is in place (not provided in all countries).
– All safety equipment is in place, is proper condition, and in the protective position.
– The PTO speed of 540 rpm is not exceeded.
– The universal shaft recommended by the manufacturer is being used.
– The hoses, cables and ropes are laid so that they do not scrape, come under tension or
become jammed or come in contact with other parts (such as the tractor tyres).
– The machine parts of the tractor do not come in contact with the machine parts of the
machine (especially when cornering).
– There are no persons in the machine danger zone.
Pos: 17.12 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
Safety
23