Krone Swadro TC 760 Bedienungsanleitung Seite 67

Pos: 31.45 /BA/Bedienung /Schwader/Bei Ausführung hydraulische Arbeitsbreitenverstellung: @ 77\mod_1310550540011_78.docx @ 669183 @ @ 1
For design with hydraulic working width setting:
Pos: 31.46 /BA/Bedienung /Schwader/Achtung Einstellen der Arbeitsbreite SW 700_800_900 @ 77\mod_1310103302890_78.docx @ 667613 @ @ 1
Caution! - Adjusting the working width
Effect: Damage to the machine
• Before extending the rotors, make certain there is no one in the danger zone of the rotors!
• Never try to adjust the working width if the tractor is switched off and the tines are in contact
with the ground.
• Only set the working width of the rotor arms in headland position.
Pos: 31.47 /BA/Bedienung /Schwader/Ausführung hydraulische Arbeitsbreitenverstellung Swadro TC 680_760 @ 215\mod_1390819656579_78.docx @ 1762373 @ @ 1
• In order to lift the rotors to the headland position, actuate the single-action control unit
(red 1+).
• In order to increase the working width, actuate the double-action control unit (blue 2+).
• In order to reduce the working width, actuate the double-action control unit (blue 2-).
Pos: 31.48 /BA/Bedienung /Schwader/Ausführung hydraulische Arbeitsbreitenverstellung Swadro TC 680_760 Zusatz Transport @ 303\mod_1414135692878_78.docx @ 2356887 @ @ 1
• CAUTION! In order to meet the transport height, retract rotors completely.
Pos: 31.49 /BA/Bedienung /Schwader/Abstand der Kreisel zum Schwadformer @ 77\mod_1310104344400_78.docx @ 667697 @ @ 1
The distance between the rotors and the swath former:
high amount of forage = long distance
small amount of forage = short distance
Pos: 31.50 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
Operation
67