Description; Installation - Acteon Endocenter Benutzerhandbuch

Notes
 None of the components are delivered disinfected or sterilized!
 Prior to installation, check the device for any damage. Report any damage sustained during shipment to your local supplier within 24
hours of receipt of the device.

4.1. DESCRIPTION

The Front panel includes:
 The LCD screen and the keyboard to display and select the required clinical mode and set the parameters (See Fig 3 for keyboard
description)
 The Ultrasonic handpiece cord connection fixed on the left side (Fig 1.1)
 The Micromotor cord connection on the right side (Fig 1.2)
 A receptacle for the irririgation hanger (Fig 1.3)
The Rear panel includes (see Fig. 2):
 The On / Off switch (Fig 2.4)
 The footswitch cord connection (Fig 2.5)
 The external power supply connection (Fig 2.6)
 The peristaltic pump system (Fig 2.7)
Multifunction footswitch
 Mode (Fig 4.1)
 Purge (Fig 4.2)
 On/Off irrigation (Fig 4.3)
 On/Off motor or ultrasonics (Fig 4.4)

4.2. INSTALLATION

Notes: The E C ™ should be connected to the electrical supply in accordance with current standards.
NDO ENTER
1. Check that the power adjustment knob is set to position OFF.
2. Check the voltage present on your power line (100V to 240V).
3. Slot the plug (in compliance
4. Connect the power cord to the E
5. Place the 4 grey silicone holders to the 4 metallic parts.
6. Place the footswitch properly to make operation easy.
7. Connect the footswitch into its receptacle at the back of the unit
8. Plug the micromotor cord to the device being careful to align the plugs and their receptacles.
9. Plug the ultrasonic handpiece on its cord (to work without irrigation) and align the electrical contacts (see Fig. 5 below). Plug the
Sterijoint in between the ultrasonic handpiece and its cord (to work with irrigation) and align the electrical contacts.
10. Plug the contra-angle onto the Micromotor.
11. Insert the bracket on its holder, and hang the bottle or bag of solution on the bracket.
12. Pull out the pump tray, insert the irrigation cassette inside the tray and close it.
13. Insert the irrigation line perforating pin into the bottle or bag and open the irrigation line by pulling back its cap.
14. Fasten the irrigation line to the cord using line clips and connect it to the sterijoint.
Notes: The Irrigation solution should satisfy the quality criteria required for dental treatment. Never use a bottle with a capacity higher than
1000 ml.
Fig. 5 Handpiece Connection
with the standards applicable in your country) onto the transformer and connect it to the main.
C ™ by inserting the connector into the receptacle on the back of the unit.
NDO ENTER
9