Description; Physical Description; Technical Description - Acteon satelec Piezotome 2 Benutzerhandbuch

III - DESCRIPTION

3. 1 PHYSICAL DESCRIPTION

P 2 has the following components:
IEZOTOME
- a control unit (Fig. 1),
- a P 2 L handpiece with its cord (Fig. 1-
IEZOTOME ED
2) (according to option),
- a N L handpiece (Fig. 1-3) (according to
EWTRON ED
option),
- a N scaler cord (Fig. 1-4) (according to
EWTRON
option),
- a grounded power cord (Fig. 1-5),
- an LCD (Liquid Crystal Display) touch screen
(Fig. 1-6),
- two cord connectors for the two ultrasonic
functions (Fig. 1-7 and 8),
- two peristaltic pump housings (Fig. 1-9),
- two brackets for irrigation solution (Fig. 1-10),
- a multifunction footswitch (Fig. 8).
Located at the back of the unit are:
- 1 power cord socket with ground pin (Fig. 2-1),
- 1 footswitch connector (Fig. 2-2),
- 1 fan (Fig. 2-3),
- 2 bracket holders (Fig. 2-4),
- 1 power switch (Fig. 2-5).

3. 2 TECHNICAL DESCRIPTION

a) LCD touch screen
The LCD touch screen (Fig. 3) is used to define
the settings of your P
The P 2 settings are adjusted by applying
IEZOTOME
reasonable pressure to the screen keys.
Identification of key areas common to all modes
(Fig. 3):
- 4: Reduce the irrigation flow rate
- 5: Increase the irrigation flow rate
- 6: Reduce value
- 7: Increase value
2.
IEZOTOME
Identification of information display areas
common to all modes (Fig. 3)
- 2: Irrigation flow rate value
- 9: Operating fault indicator
Identification of key areas common to all modes
that also display information (Fig. 3)
- 1: Flush/prime
- 3: Irrigation ON/OFF
- 8: Save, store data
- 10: Select footswitch mode
- 11: Handpiece light ON/OFF
- 12: Select mode (according to connected
handpiece type)
Key areas and displays specific to the selected
mode
P mode:
IEZOTOME
Identification of information display areas (Fig. 4)
- 13: Selected program power level
Identification of key areas that also display
information (Fig. 4)
- 14: Select program: D1, D2, D3, D4
N mode:
EWTRON
Identification of information display areas (Fig. 5)
- 15: Selected program power level
Identification of key areas that also display
information (Fig. 5)
- 16: Select program: Soft, Medium, High, Boost
Startup page:
Identification of key areas (Fig.6)
- 17: Enter mode
TOOLBOX
7