Use In Rotating Mode - Acteon Endocenter Benutzerhandbuch

Speed
Sets motor rotation speed in Rpm. See the available values in the following table:
1:1
1000
1500
2000
2500
3000
3500
4000
4500
5000
5500
6000
6500
7000
7500
8000
8500
9000
9500
10000
A/R mode
Set the type of Auto reverse mode by pressing directly on "AR MODE" key:
STP: Autoreverse "OFF"
 When set the torque value is reached, the motor stops without rotation.
AR: Autoreverse "standard"
 When the file reaches the set torque value, the motor runs reverse until the motor has been stopped. Next start will be in Fo rward.
SAR: Autoreverse "special"
 When file reaches the set torque value, the motor runs reverse until it has freed the file. Then the motor runs again automatically in
forward.
Notes
AR and SAR modes are in use only if the torque is not set on Max.
Beeping sound notifies user when 75% of the preset torque has been reached and when preset torque limit has been exceeded.
Flow:
Set the value of the irrigation flow from 0 to 9.

5.3 USE IN ROTATING MODE

Once the parameters have been set:
1. Fit an instrument (file) to the contra-angle.
2. Check the integrity of the device and its accessories before use in order to detect any problem. Do not use the device if it appears to
be damaged or faulty.
3. Press the footswitch (Fig. 4.4).
4. The motor starts running.
Speed vs Contra-angle Ratio
6:1 8:1
150 125
200 150
250 200
300 250
350 300
400 350
450 400
500 450
550 500
600 550
650 600
700 650
750 700
800 750
850 800
900 850
950 900
1000 950
1100 1000
1200 1100
1300 1200
1400 1250
1500
1600
16:1 20:1
100 100
150 120
200 150
250 200
300 250
350 280
400 300
450 350
500 400
550 450
600 500
32:1
100
150
175
180
200
250
280
300
12