Configuration; Web Interface; Products Equipped With Firmware Version Prior To 2.1 - Videotec ULISSE MAXI NETCAM Bedienungsanleitung

10 Configuration

10.1 Web interface

The unit is configured to obtain an IP
address from a DHCP server.
Browsers supported: Microsoft Internet
Explorer, Google Chrome, Mozilla Firefox.
The MAC Address is contained on the label
that is on the CPU board.
Fig. 59
The first operation in configuring the device consists
in connecting to the web interface.
The IP address acquired via DHCP is visible in the
DHCP server log file.
If the DHCP server is not available, the unit
automatically configures itself with a self-generated
IP address in the 169.254.0.0/16 subnet. Configuring
the IP address of the PC as belonging to the same
subnet (example: IP address: 169.254.1.1, subnet
mask: 255.255.0.0).
Use an ONVIF compatible VMS, the ONVIF Device
Manager application or a network sniffer to find the
IP address of the device (IP scan utility).
To access the Pan & Tilt web interface, simply use a
browser to connect to the address http://ip_address.
The access credentials to the device will be the
same as the user name and password specified to
communicate with the camera. (10.1.2 First access to
the web pages, page 35).
34
10.1.1 Products equipped with firmware
version prior to 2.1
During the first connection assign an
address other than 192.168.0.100.
In the predefined settings for the configured P&T,
to automatically acquire an address through a DHCP
protocol, it is possible to detect the device through
the ONVIF, S profile, protocol.
If no DHCP server is available, the P&T unit will
configure itself automatically with the address
192.168.0.100.
If no VMS is available with the Auto Discovery
functions based on ONVIF, the acquired address can
be read in the DHCP server logs.
To access the Pan & Tilt web interface, simply use a
browser to connect to the address http://ip_address
and log in to Pan & Tilt using the predefined
credentials:
• Username: admin
• Password: admin
MNVCUPTMAXIR_1625_EN