Activation Of The Led Illuminator Via An External Dusk Switch; Activation Of The Led Illuminator Via The Integrated Dusk Sensor; Manually Activate The Led Illuminators - Videotec ULISSE MAXI NETCAM Bedienungsanleitung

8.11.2 Activation of the LED illuminator
via an external dusk switch
Perform the following operations:
• Connect the twilight switch to the terminals: AL1/
ALARMS (8.4.3 Connection of the alarm inputs, of
the twilight switch and of the relays, page 23).
• Adjust the left illuminator (MASTER):
• Lighting threshold: Set the value to OFF (
8.11.5 LED illuminator switching on threshold
adjustment, page 29).
• Infrared power: Set the value as needed (8.11.6
LED illuminator power adjustment, page 29).
• Adjustment of the the illuminator on the right
(SLAVE):
• Lighting threshold: Set the value to the
maximum (8.11.5 LED illuminator switching on
threshold adjustment, page 29).
• Infrared power: Set the value to the minimum (
8.11.6 LED illuminator power adjustment, page
29).
From the IR Probe entry select the External option (
10.1.14 Camera Settings page, page 41).
On the I/O digital board, set the values in the
following manner: (10.1.12 Digital I/O Page, page 40):
• Alarm ID: 1
• Type: NORMALLY OPEN
• Action: IR_FILT
8.11.3 Activation of the LED illuminator
via the integrated dusk sensor
To synchronise the unit with the LED illuminators it is
necessary to:
• Adjust the left illuminator (MASTER):
• Lighting threshold: Set the value as needed (
8.11.5 LED illuminator switching on threshold
adjustment, page 29).
• Infrared power: Set the value as needed (8.11.6
LED illuminator power adjustment, page 29).
28
• Adjustment of the the illuminator on the right
(SLAVE):
• Lighting threshold: Set the value to the
maximum (8.11.5 LED illuminator switching on
threshold adjustment, page 29).
• Infrared power: Set the value to the minimum (
8.11.6 LED illuminator power adjustment, page
29).
From the Camera Parameters entry select the Internal
option (10.1.14 Camera Settings page, page 41).
8.11.4 Manually activate the LED
illuminators
To turn on the LED illuminators:
• Adjust the left illuminator (MASTER):
• Lighting threshold: Set the value to OFF (
8.11.5 LED illuminator switching on threshold
adjustment, page 29).
• Infrared power: Set the value as needed (8.11.6
LED illuminator power adjustment, page 29).
• Adjustment of the the illuminator on the right
(SLAVE):
• Lighting threshold: Set the value to the
maximum (8.11.5 LED illuminator switching on
threshold adjustment, page 29).
• Infrared power: Set the value to the minimum (
8.11.6 LED illuminator power adjustment, page
29).
From the IR Probe entry select the None option (
10.1.14 Camera Settings page, page 41).
MNVCUPTMAXIR_1625_EN