Connection Of The Led Illuminators; Setting Of The Led Illuminators And Synchronization Mode With The Camera; Description Of The Led Illuminator - Videotec ULISSE RADICAL Bedienungslanleitung

7.8 Connection of the LED
illuminators
Insert the power supply cables through the cable
glands by at least 25 cm.
25cm
Fig. 25
To ensure the safety and the correct
operation of the unit do not leave a surplus
of the cable externally.
Fig. 26
Connect the cables as shown in figure.
The left illuminator (MASTER) must be connected to
connector J15. The right illuminator (SLAVE) must be
connected to connector J9.
Black
White
Red
Green
Fig. 27
MNVCUPKPLUS_1514_EN
25cm
J9 J9
J15 J15
7.9 Setting of the LED
illuminators and synchronization
mode with the camera
Once the adjustment is done the
illuminator on the left (MASTER)
synchronizes and controls the illuminator
on the right (SLAVE).
The dusk switch detects the room light and controls
the activation and deactivation of the illuminators
when brightness reaches the level set by the user.
When the LED illuminators are active the camera
goes to night mode with the special ONVIF control.

7.9.1 Description of the LED illuminator

Do not remove the transparent screw of the
twilight sensor in order not to affect the
security and operation of the illuminator.
• Twilight sensor: Detects the light level.
• Cable: Power supply and control.
• Switch-on threshold regulator: The
potentiometer allows adjusting the sensitivity
threshold to switch on the illuminator.
• Infrared power control: The potentiometer allows
adjusting the power of the illuminator.
Twilight sensor
Switch-on threshold
regulator
Fig. 28
Cable
Infrared power control
19