Connection To Vehicle - Bosch OBD 150 Originalbetriebsanleitung

¶
Ensure adequate ventilation if the OBD 150 is
used with the engine running.
¶
In Germany and other EU countries it is not
permissible to operate the OBD 150 whilst
driving.
¶
Pull the OBD diagnostic connector and not
the cable to disconnect the OBD 150 from
the vehicle.
5.2

Connection to vehicle

i
The OBD 150 is supplied with power by way
of the vehicle OBD interface or via the USB
interface of a connected computer.
i
The language setting (language selection)
appears the first time the OBD 150 is
switched on. Select the language required
and confirm with E. This language selection
screen appears each time the OBD 150 is
turned on until a language has been chosen.
The language can be altered at any time (see
Section 5.16).
1. Locate the OBD diagnostic socket in the
vehicle.
i
The OBD diagnostic socket is usually situated
in the driver's footwell in the area of the
center console or in the glove compartment.
The installation location can also be looked
up in the maintenance manual of the vehicle
concerned or found in the internet.
2. Remove the cover over the OBD diagnostic
socket if necessary.
3. Switch on the ignition (position 2).
!
Do not start the engine.
Robert Bosch GmbH
Operation | OBD 150 | 33
4. Insert the OBD diagnostic connector of the
OBD 150 in the OBD diagnostic socket of the
vehicle.
 The OBD 150 is switched on.
 The OBD diagnostic data are read out.
"
The results of the quick test are displayed.
$
I/M-Monitors
$
Read Codes
i
The content of the quick test can be viewed
with or
READ ERASE
i
Go to the diagnostic menu by pressing z or E.
569630 Rev "D"
en
.
|
2016-02-19