Prerequisites; Hardware; Software; Scope Of Delivery - Bosch KTS 5a Serie Originalbetriebsanleitung

3.2

Prerequisites

The KTS 560 / 590 (KTS 5a Series) can only be
operated from a computer and with the ESI[tronic]

software.

3.2.1

Hardware

R
Operating system: Windows 8 or Windows 10
R
CPU (processor): 1.6 GHz or higher
R
At least 100 GB of free hard drive space
R
4 GB of RAM or more
R
Display resolution of 1024 x 600 pixels or higher
R
LAN: 10/100 Mbit/s, WLAN: 802.11b/g/n
R
6 Mbit/s or higher
R
Two vacant USB ports for the Bluetooth USB
adapter and for a USB connecting cable
3.2.2 Software
In order to operate the KTS module, the current
ESI[tronic] 2.0 software must be installed and
licensed on the computer. This is subject to additional
cost.
3.3

Scope of delivery

i
The scope of delivery depends on the product
variant ordered as well as the special accessories
ordered, and can deviate from the following list.
Designation
Diagnostic device KTS 560
Diagnostic device KTS 590
Bluetooth USB adapter
OBD connection cable, 1.5 m
USB connection cable 3 m
Power supply unit
Measurement cable blue/yellow
Measurement cable red/black (KTS 590 only) 1 684 463 945
Measuring clamp black
(1x on KTS 560, 2x on KTS 590)
Test prods
Test prods
Protective cap
Case
Mounting bracket with 3 oval-head screws
Important information and safety instructions 1 689 979 922
Instruction manuals
3.4

Special accessories

Information on optional accessories, such as vehicle-
specific connection cables, extra measurement cables
and connection cables can be obtained from your
Bosch authorized dealer.
Robert Bosch GmbH
Device description | KTS 560 / 590 (KTS 5a Series) | 17 |
3.5

System tester

3.5.1

Diagnosis terminals/Measurement terminals

Fig. 1: Diagnosis terminals/Measurement terminals KTS 560
1 Measurement input CH1(–), blue
2 Measurement input CH1(+), yellow
3 Connection for OBD connecting cable (DIAG)
1
Diagnosis terminals/Measurement terminals KTS 590
Fig. 2:
1 Measurement input CH2(+), red
2 Measurement input CH2(–), black
3 Measurement input CH1(–), blue
4 Measurement input CH1(+), yellow
Order number
5 Port for OBD connection cable (DIAG
–
–
3.5.2

Connection panel

–
1 684 465 755 /
1 684 465 881
1 684 465 562
1 687 023 736
1 684 463 950
1 681 354 035
1 683 050 050
1 684 480 125
Fig. 3: Connection panel
1 680 591 037
1 Memory card slot (not functional)
1 685 438 648
2 Power supply unit connection
–
3 USB port
4 Bluetooth USB adapter (plugged in at the factory)
1 689 989 223
1 689 989 266
1 689 989 277
1 2 3
459963-03_Ht
2 3 4 5
459963-05_Ht
1 2 3 4
459963-06_Ht
1 689 989 223
en
|
2021-09-24