Scheppach HP2500S Originalbetriebsanleitung Seite 44

NOTE!
Risk of damage!
If the product is not stored properly, the engine can be
damaged.
- Store the product protected against dirt, dust and
moisture.
13.1 Storage during extended breaks in operation:
If the plate compactor will not be used for a period of
more than 30 days, follow the steps below to prepare
it for storage.
1. Empty the fuel tank completely (see section 13.4).
Stored petrol containing ethanol or MTBE be-
comes stale within 30 days. Stale petrol has a high
rubber content and can thus clog the carburettor
and restrict the petrol supply.
2. Drain the engine oil from the engine while it is still
warm. Top up with new oil. (See section 13.3.)
3. Use clean cloths to clean the plate compactor.
4. m Do not use aggressive or oil-based cleaning
agents when cleaning the plastic parts. Chemi-
cals can damage plastics.
5. Store the plate compactor in an upright position in
a clean, dry building with good ventilation.
Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the device in its original packaging.
Cover the device to protect it from dust or moisture.
Store the operating instructions with the device.
14. Repair & ordering spare parts
After repairs or maintenance, make sure that all safe-
ty-related parts are installed and are in perfect con-
dition. All parts which may cause injury must be kept
where they are inaccessible to children or others.
Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by im-
proper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
44 | GB
Connections and repairs
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any queries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
Important note in the case of repairs:
For return delivery of the product for repair, please en-
sure for safety reasons that it is free of oil and fuel when
it is sent to the service centre.
14.1 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Petrol suction pump ............................... 7907600001
14.2 Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Spark plug, oil, belt, rubber pad, air
filter
* may not be included in the scope of delivery!
15. Disposal and recycling
Notes for packaging
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the device, the fuel tank and the
engine oil tank must be emptied!
www.scheppach.com
Article no.:
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.