Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.13
Update menu (FW inverter update / accessories)
The indicated data is only indicative
COM
ENTER
FIRMWARE M1
FIRMWARE M2
FW EXP1
FW EXP2
ENTER
ON LINE:
BYTES REC:
BYTES PRG:
STATUS:
ENTER
STATUS:
STATUS:
ON LINE:
BYTES REC:
BYTES PRG:
STATUS:
ENTER
FIRMWARE M1
FIRMWARE M2
FW ACC.M1
FW ACC.M2
ENTER
92
SERIAL
WIFI
UPDATE
ESC
ESC
MOT1
_ _ _ _ _ _ _
ESC
PRELUDE
LOADING
MOT1
88 068
88 068
DONE
ESC
B73/KEYS
ESC
the motor (FIRMWARE M1, FIRMWARE M2), or of the
potential of the B74/BCONNECT device on which the
be downloaded in advance.
1) Select the device on which you wish to perform the
FIRMWARE M2 menus you will enter the page dedicated
to data communication. If, on the other hand, the FW
update of accessories is chosen, a selection menu opens
with which the accessory to be updated can be chosen.
2) After executing point 1, access the WEB application
page from the dedicated FW update menu.
3) Start the update procedure by selecting the command
APP B74/BCONNECT.
The following indications appear on the display in
sequence (see display on the left).
attempt, repeat until the desired result is obtained. In the
event of an anomaly, the programming sequence may be
of the inverter will compromised until such time as the
procedure has been completed (the two red and green
(or moor 2) without opening the control unit, you can
1) Select parameter
, FUNCTIONALITY category, in the
B-CONNECT application and set value 01 (motor 1) or
(UPDATE M2) menu
the APP
3) once the update is completed , set parameter
this will reset the control unit and will load data from the
perform a repositioning cycle (the reset causes position
to be lost).
to
to value
will upgrade
B73/KEYS
Werbung
