NOTE: the parameter is saved to the control unit memory and the memory of the inverter on board the motor (if the
parameter in question is dedicated to it).
M1
RESET
E
R
R
ENTER
Restoring the factory default values
NOTE: this procedure is only possible if the protection password has not been
,
,
.
When parameter
together for 5 sec., the following icon appears on the display indicating that
the parameters of the control unit have been reset to factory values; once this
operation is completed, the parameters dedicated to motor 1 and motor 2 are
saved in the inverters, thus obtaining the initialization of the complete system
(control unit and motors) to factory values.
WARNING! Wait until the icon is extinguished (operation complete) before
changing the menu page.
Parameter errors
The message ERR indicates that there is at least one error on the parameters
by the letters "EE
If the error is in the EEPROM memory of F70/IPU36, a toothed cursor appears
below the box; if the error is due to a discrepancy between the value in the F70/
IPU36 memory and the value in the inverter 1 or 2 memory,
will be displayed
sing to set the desired value. After saving the correct value, if there are any
more error parameters, move onto the next one. Once all the errors have been
ESC
M2
is displayed and the "+" and "-" keys are pressed and held
ENTER
M1
M2
,
,
,
,
,
,
,
or
1
2
ESC
,
-
77