Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.12
WiFi menu (with B74/BCONNECT)
The indicated data is only indicative
By connecting the Roger B74/BCONNECT module to the F70/IPU36 WiFi connector, it is possible to update
the Firmware for the F70/INV36/1, or the two inverter modules on board the motor (having activated the
COM
ENTER
TRAFFIC
QUALITY
DBM ROUTER
STATUS
ENTER
SERIAL
WIFI
UPDATE
ESC
WAIT
100%
---
APx/CL
ESC
accessed only if the connection has been enabled in the
"Serial communication" menu and TARGET = B-CONN
has been selected
If the B-CONN value has been selected from the SERIAL
menu, it indicates that communications between B74/
BCONNECT and F70/IPU36 are not active. Under normal
conditions, if B-CONN is not selected in the SERIAL
menu, 'OFF' will be indicated.
indicates the percentage of communication attempts
is generally 100%
ROUTER DBM indicates the signal strength of the WiFi
router to which B74/BCONNECT is connected; IDLE
indicates if there is no connection. A value from -80dBm
down indicates a weak WiFi connection.
If "CL" is enabled, this means it's connected to the Cloud.
If "AP" is enabled, followed by a number, indicates an
"Access Point" type connection and the count of the A.P.
connections.
Return to the previous menu
COM
91
Werbung
