Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Battery type selection and consumption reduction
36V
(3x12 V
) battery with B71/BCIPU coupling battery charger. Acceleration/deceleration/speed reduction
36V
(3x12 V
) battery with B71/BCIPU coupling battery charger. No performance reduction, maximum battery
consumption.
36V
(3x12V
increase the battery life.
36V
(3x12V
Selection of the battery operation management
Setting a value different than
via parameter
and an error alert can be activated through the COR output via parameter 18.
The control unit always accepts commands until the battery is completely exhausted (35.4V
The command becomes active when the battery voltage drops to the minimum threshold (36.4V
The command becomes active when the battery voltage drops to the medium threshold (36.8V
The command becomes active when the battery voltage drops to the maximum threshold (37.2V
Enabling of regular maintenance activation
N.B.: Parameter visible if any password other than the default password is set (00000000).
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
When the manoeuvre hour limit (set by
1500 manoeuvre hours).
ATTENTION: a manoeuvre is any activation of the automation system while being open.
On the display below the parameter box the symbol
system maintenance is performed and the alarm is reset.
To reset the alarm, unlock the protection by entering the password and press the "+" and "-" keys for 5 s. The symbol
disappears from the display, the number of operating hours is stored in the memory and the count starts again.
N.B.: When 9990 hours of operation are exceeded, the maintenance alarm is disabled entirely.
Disabled.
Maintenance enabled for a period = parameter value
Maintenance enabled for a period = parameter value
Adjustment of regular maintenance activation hour counter
N.B: Parameter visible with parameter
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
Disabled.
from 10 to 990 hours with parameter
from 100 to 9990 hours with parameter
Cyclical activation (test mode)
selected (par.
and par.
).
Disabled.
Opening command activated every 15"...90".
Opening command activated every 1"...9".
NOTE: set
or
to modify the displayed menu, switching to the updated version; to perform the update, it is
necessary to use B74/BCONNECT and the corresponding WEB application
Setting the value
forces the F70/IPU36 to reset
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
Pressing and holding the "+" and "- "keys for 4 seconds resets the standard parameters (see the description at par. 10.2)
a battery voltage level check is activated. The desired operation type can be selected
and
) is exceeded, the visual maintenance signal is activated (e.g. every
is shown, followed by the number of hours since the last
x10 hours.
x100 hours.
or
.
.
.
, lighting of icon
for battery 3x12V
).
for battery 3x12V
).
for battery 3x12V
).
111
Werbung
