Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Photocell (FT2) mode with gate closed
N.B.: this parameter is not visible if
If the photocell is obstructed, the gate cannot open.
The gate opens when an open command is received, even if the photocell is obstructed.
The photocell sends the gate open command when obstructed.
Enable close command 6 s after activation of photocell (FT1-FT2)
This parameter is not visible if
6 secs. count starts when the wings are completely open.
Disabled.
Enabled. When the photocell gate FT1 is crossed, a close command is sent 6 seconds later.
Enabled. When the photocell gate FT2 is crossed, a close command is sent 6 seconds later.
Selecting contact type (NC or 8.2 kOhm) on inputs FT1/FT2/ST
In conformity with the safety regulations EN12453-EN12445, devices using an 8.2 kOhm contact instead of an NC
contact may be connected to inputs FT1/FT2/ST.
Selecting the type of photocell test on input FT1
This parameter is visible if
connected to input FT1 are working properly. The test lasts max. 3 s OFF / 3 s ON.
Selecting the type of photocell test on input FT2
This parameter is visible if
connected to input FT2 are working properly. The test lasts max. 3 s OFF / 3 s ON.
Photocell test disabled.
Photocell test enabled on opening ONLY.
Photocell test enabled on closure ONLY.
Photocell test enabled on both opening and closure.
Enable MOTOR 1 limit switch
NOTE:
Enable MOTOR 2 limit switch
NOTE:
Limit switches disabled.
Opening limit switch only.
Closing limit switch only.
Both limit switches.
Enable MOTOR 1 braking
NOTE: this parameter is displayed only if required by the MOTOR 1 type (REVERSIBLE or HIGH-SPEED).
Enable MOTOR 2 braking
NOTE: this parameter is displayed only if required by the MOTOR 2 type (REVERSIBLE or HIGH-SPEED).
Electrical braking when motor stopped disabled.
Electrical braking enabled.
Setting MOTOR 1 stop distance
Setting MOTOR 2 stop distance
= faster deceleration/shorter stop distance ...
108
or
or
is set. NOTE: in the case of photocells being blanked during opening, the
FT1
8k2
N.C.
8k2
N.C.
8k2
N.C.
8k2
or
is set. If the photocell test is enabled, the control unit will check the photocells
or
is set. If the photocell test is enabled, the control unit will check the photocells
or
is set.
FT2
N.C.
8k2
8k2
N.C.
N.C.
8k2
8k2
= slower deceleration/longer stop distance.
ST
N.C.
N.C.
N.C.
8k2
8k2
8k2
8k2
Werbung
