Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.3
Command/safety devices/outputs status display menu
The indicated data is only indicative
F70/IPU36
ENTER
x2 click
AP
PP
ORO
RX2
ENTER
ST
COS2
FT2
ENTER
LAM
SC
LOCK
STATUS:
ENTER
78
R1.50
ESC
CH
PED
RX1
ESC
COS1
FT1
ESC
ES
COR
0 2 2
ESC
COMMAND INPUTS STATUS DISPLAY
If the corresponding panel is blacked out, it means the
command is active.
SAFETY DEVICE INPUTS STATUS DISPLAY
If the corresponding panel is blacked out, it means the
safety device is active and at rest; if the panel is empty,
it means the safety devices is in the alarm state. If the
name of the safety device is not displayed, it means it
has been disabled by the respective parameter.
under control, the following indications may appear on
(FA1, FA2), closure (FC1, FC2) and release (SBL1, SBL2)
limit switches.
Some types of automation may include functions managed
by additional sensors, the status of which can therefore
If the total number of safety devices exceeds the 8
positions available on the page, press the "-" key to scroll
downwards to view the remaining positions, and the "+"
Return to the previous menu
OUTPUTS INPUTS STATUS DISPLAY
If the corresponding panel is blacked out, it means the
intermittently by the control unit, then the indication on
the display will be too.
LAM, ES, SC, COR are outputs of F70/IPU36; in addition,
if present, there are indications of inverter-driven outputs
in motor 1 is powered (deadbolt unlocked).
These numbers indicate the communication status at the
F70/IPU36, inverter 1 and inverter 2 levels.
If everything is normal, the numbers vary very quickly,
returning periodically to 0, whereas if anything is blocked,
Werbung
