Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.5.1
Error alarms
ALARM
DESCRIPTION
Short circuit detected on motor phases
Overload detected on motor
Overheating detected on motor
Motor thermal cut-out tripped
Motor malfunction or motor phases not connected
V
Motor power supply voltage too high
V
Motor power supply voltage too low
Collision detected
Loss of motor control detected, execute motor
re-calibration procedure
Calibration error in motor current check
inverter functions from being restored automatically
when active. Contact Customer Service.
Activation of the voltage limiter (external power
BLD
resistor connected between terminals 5 and 6)
BLD
Overload detected on the voltage limiter (resets
after 5 seconds)
sor can be moved using the
INVERTER) and its summary description.
conditions persist.
In the event of an alarm condition, the screen with one of the following possible indications appears on the display at
- INV.FW 1 or INV.FW 2 or INV.FW 1-2
limit functions or even block the automation system and can occur if different versions of F70/IPU36 and F70/INV36/1
- ALARM or WARNING
alarm/warning icon is active.
- M. RELEASE
the automation system from starting; it is possible to view the status of the release on the safety device display page.
- SEL.MOT
therefore F70/IPU36 is in the forced STOP state (it is not possible to start the automation system). Set the correct
value of par.
(or
).
- 24V OFF
seconds).
appears while the operator continues to scroll through the page (using the keys around the display); the alternating
display mode resumes 10 seconds after the last key is activated, thereby drawing the operator's attention to the active
alarm.
82
and
keys. Pressing ENTER displays the alarm category (MEMORY ALARM, ENCODER,
ALARM
DESCRIPTION
motor cable from the control, wait for 10 seconds
then reconnect it, check whether the alarm has been
cancelled
error, magnet damaged or unstable
Calibration data absent from the inverter EEPROM
procedure
Motor calibration procedure failed, rotor position
measurement out of tolerance
Encoder magnet absent or damaged; inverter not
positioned correctly or not secured to motor
Motor rotor blocked (cannot perform calibration
procedure)
Data error detected in the EEPROM of the inverter on
board the motor
Position unknown, repositioning phase in progress
No communication with inverter 1
1
No communication with inverter 2
2
R
Motor model selection error (model not compatible
with the inverter)
ID
Error detected on the motor technical board, contact
Customer Service
-
Werbung
