Werbung
Verfügbare Sprachen
Verfügbare Sprachen
UNLOCK MOT1
CONF. UNLOCK MOT1
PRESS ENTER
ENTER
PROGRAM. MOT1
PRESS ENTER
ENTER
Once programming is complete the message RUN is replaced by the message PASS (if the process was completed
successfully) or FAIL if it failed.
PM1 = Programming Motor 1
PM2 = Programming Motor 2
If only one motor is being programmed, the other one displays "----"
FAIL (programming failed).
UNLOCK MOT1
CONF. UNLOCK MOT1
PRESS ENTER
ENTER
FM1 = Calibration Motor 1
FM2 = Calibration Motor 2
The calibration procedure may result in two successful outcomes OK_A
possible to release the motor or there were problems activating the rotor.
UNLOCK MOT1
CONF. UNLOCK MOT1
PRESS ENTER
ESC
ENTER
Pressing ESC exits the menu without saving anything
INSTALLATION DATE
MONTH:00 YEAR:00
CONFIRM
MONTH:00 YEAR:00
ENTER
CALIBR MOT1
ESC
ENTER
APP-
PROGRAM. MOT1
PM1:OPEN
ESC
ENTER
OPEN (OPENING), PAUS (PAUSE), CLOS (CLOSING), PASS (programming OK),
CALIBR
FM1:RUN
ESC
ENTER
CLOSE THE GATE
LOCK MOTORS
CONF. CLOSED
PRESS ENTER
ESC
ENTER
INSTALLATION DATE
MONTH:06 YEAR:23
CONFIRM
MONTH:06 YEAR:23
ENTER
ESC
RUN
ESC
RUN
PM2:----
ESC
MOT1
RUN
FM2:----
ESC
PROGRAM. MOT1
APP-
PRESS ENTER
ESC
ENTER
ESC
CLOSE THE GATE
LOCK MOTORS
CONF. CLOSED
PRESS ENTER
ESC
ENTER
Programming example for a
single leaf
CALIBR
MOT1
PASS
FM1:OK_A
FM2:----
PRESS ENTER
ESC
ENTER
OK_B (blocked
PROGRAM. MOT1
RUN
PM1:OPEN
PM2:----
ESC
ENTER
DATE STORED!
ESC
ENTER
89
Werbung
