Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.4
Gate position and INFO values display menu
The indicated data is only indicative
F70/IPU36
ENTER
x3 click
M1 installed on the left
M1
0
CNT
0
LUN
0
RPM
ENTER
M2 installed on the left (
M1 on the right (
M2
0
CNT
0
LUN
0
RPM
ENTER
101
010
100%
DAT
100%
INF
ENTER
Return to the Welcome menu
80
R1.50
ESC
ESC
),
)
M1
0
0
0
ESC
100
011
100%
100%
ESC
Return to the previous menu
If the motor values are not read correctly during the initial
automation system start-up phase (following switch-on)
the message "----" is display in place of the values.
the icon M1 (and M2 in the case of double gate installations)
is displayed in the part (left/right) corresponding to the
or
SINGLE GATE CONFIGURATION (par.
values supplied by MOTOR 1 (CNT, LUN, RPM, ...) appear
in the part of the display below the icon M1.
Use the + or - to scroll through the list of INFO values,
which are always displayed in groups of three.
M1
M1
DOUBLE LEAF CONFIGURATION (par.
values supplied by MOTOR 1 (CNT, LUN, RPM, ...) appear in
the part of the display below the icon M1, while the INFO
values supplied by MOTOR 2 appear below the M2 icon.
Use the + or - to scroll through the list of INFO values,
which are always displayed in groups of three.
M2
M1
M2
M1
The list of INFO values associated with the motors is followed
- IPUBUS motors power supply voltage
- IPUAMP current drawn by the motors
- IPU_ST
digital status of the automation system
- IPU_UP
position of both motors known
position M1 unknown
position M2 unknown
position of both motors unknown
-IPU_OC
fully closed
closing
opening
fully open
-IPU_UF
voltage value too low
excess current drawn by motors
This page displays information on the quality of the
RS485 communications between the F70/IPU36 and the
inverter modules on board the motor.
The percentage of successfully transmitted motor operating
data messages is indicated next to the DAT icon (100 = no
the INFO data messages appears next to the INFO icon.
A persistently low value indicates the presence of communication
issues, and if this occurs it is advisable to check the quality of
the connection cable, its cross section and the way it is routed.
.
=
LEAF CLOSED
LEAF OPEN
=
LEAVES CLOSED
LEAVES OPEN
Werbung
