Example Of Updating E.sylink - DAB DCONNECT BOX Anleitung

10.12 Example of updating e.sylink

This Update is necessary to allow the e.sylink accessory with older software to be regularly recognised by
the DConnect Box. The update will take 1 minute.
Initial requirements:
• Manual of the product to be connected.
•
DConnect Box already updated and powered, see sec. Updating the DConnect BOX in this manual.
The connection between DConnect Box and e.sylink requires the use of a USB cable male A - male
B. See photo.
1. Make sure that the E.sylink is not powered.
2. Power the DConnect Box (already updated, see sec. Updating the DConnect BOX) and wait
about 90 sec.
3. Insert the type A connector of the USB cable into one of the 4 USB ports available on the
back of the DConnect Box.
4. Hold down the left button
the USB cable into the port on the top of the e.sylink.
5. Press and hold the left button of the DConnect Box for 10 seconds until you hear 2 beeps
and the wireless link LED
6. Wait 60 sec and remove the USB cable.
7. Power and use the e.sylink as usual.
NOTE: Remember that before associating the e.sybox pumps and the e.sylink
accessory with the DConnect Box it is necessary first to create the association
between the pumps and the e.sylink accessory (page AS) and then to associate any
pump of the above-mentioned group with the DConnect Box
ENGLISH
on the E.sylink and insert the remaining connector (type B) of
flashes twice.
58