Example E.sybox Mini3 Update (Sw 1.X Versions) - DAB DCONNECT BOX Anleitung

10.11 Example e.sybox mini3 Update (Sw 1.X versions)

This Update is required to allow e.sybox units with older software to be regularly recognised by the
DConnect Box. The update takes about 2-3 minutes.
Initial Requirements:
• Make sure that the product has a software version (Sw) 1.X or lower (see page VE of the pump
menu); if it is higher, e.g. "2.X", the update is not necessary, so see section "Example e.sybox
Connection (Sw 2.X versions)" of this manual.
• Manual of the product to be connected.
•
DConnect Box already updated and powered, see section Updating the DConnect BOX of this
manual.
The connection between the e.sybox mini3 and the DConnect Box does not require any cable.
1. Make sure that the e.sybox mini3 is not powered.
2. Power the DConnect Box (already updated, see section Updating the DConnect BOX ) and
wait about 90 sec.
3. Press and hold the left button of the DConnect Box for 10 seconds until you hear 2 beeps
and the wireless link LED
4. Within 45 seconds from the previous operation, press and hold the buttons
power the e.sybox mini3 product until the message "LV LOADER X.X" appears on the display.
5. The LED of the wireless connection
DConnect Box and the pump to be updated has been established.
6. On the display of the e.sybox, a progress bar will show the status of the update. It consists of
two steps and takes 2-3 minutes.
7. Once the update is successful, the e.sybox mini3 will restart automatically.
8. To continue the connection to the DConnect box, refer to section "Example e.sybox mini3
Connection (Sw 2.X versions)" of this manual.
flashes twice.
Figure 9D - Loader access for e.sybox mini3 Sw 1.X update
ENGLISH
will remain lit once the connection between the
57
and