Deleting Data From Memory; Keeping Data In Memory; Service And Repair; Service And Repair Contact - Hürner HWT 400–WeldControl Bedienungsanleitung

If the welding unit recognizes a problem that cannot be
cleared while the data transfer is in progress, it does not
resume the process and displays a "Download cancelled"
error message. To acknowledge this error, press the START/
Info
SET key.
6.7

Deleting Data from Memory

The report data in memory can be deleted only after all welding reports
were transferred, which is indicated by the "Download completed"
message. When the storage media is unplugged, a "Delete Memory"
message appears. If the START/SET key is pressed at this point, a fur-
ther confirmation message "Delete Memory, sure?" is shown, which
has to be confirmed by pressing the START/SET key once again. Then,
the report data in memory are deleted.
6.8

Keeping Data in Memory

When the cable or storage media is unplugged, a "Delete Memory"
message is displayed. Press the STOP/RESET key to keep the current
report data in memory. They can then be printed off once again.
When transferring welding reports to a USB stick, always
be sure to wait until the display shows the "Download fin-
ished" message before you disconnect the USB stick from
Important
the product. If you disconnect it too early, the unit may ask
you whether you want to delete the reports in memory, al-
though they were not properly transferred. In this case, if
you delete the contents of the report memory, the welding
reports would be irrevocably lost and would not be available
elsewhere either.
7

Service and Repair

As the product is used in applications sensitive to safety considerations,
it may be serviced and repaired only on our premises or by partners
who were specifically trained and authorized by us. Thus, constantly
high standards of operation quality and safety are maintained.
Non-compliance with this provision will dispense the manu-
facturer from any warranty and liability claims for the product
and any consequential damage.
Important
8

Service and Repair Contact

Hürner Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specifications of
the product without prior notice.
Info
Pursuant to the directive 2002/96/EC on Waste Electrical and Electronic
Equipment (so-called WEEE Directive), equipment that was manufac-
tured or distributed by ourselves may be returned to us. To discuss
the exact procedure we will follow, please contact us with the details
above.
34
EN
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HÜRNER HWT 400–WeldControl User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Version January 2020