Fuel System; Fuel Line Inspection - Yamaha Waverunner XLT1200 Wartungshandbuch

INSP
ADJ
CONTROL SYSTEM/FUEL SYSTEM
3. Adjust:
YPVS cables 1 and 2
Adjustment steps:
Loosen locknuts 1 and 2.
Turn in adjusters 3 and 4 until there
is slack in the cables.
Align the hole a in the pulley with the
hole in the cylinder.
Insert a 4-mm-diameter pin through
the holes in the pulley and cylinder.
Turn adjusters 3 and 4 in or out until
the specified slack is obtained.
Turn in
Turn out
Finger tighten locknuts 1 and 2.
Remove the pin.
Start and stop the engine.
Recheck the hole alignment.
If the hole alignment is correctly,
tighten the locknuts.
If the hole alignment is incorrect,
repeat the above steps.

FUEL SYSTEM

WARNING
Stop the engine, set the fuel cock to
"OFF" before servicing the fuel system.
When removing fuel system parts, wrap
them in a cloth and take care that no fuel
spills into the engine compartment.

Fuel line inspection

1. Inspect:
Fuel filter 1
Contaminants → Replace.
Cracks/damage → Replace.
Water contamination → Replace and
check the fuel tank.
Fuel hoses
Fuel tank
Fuel hoses through part
Fuel filler cap
Cracks/damage → Replace.
3-8
Slack is increased.
Slack is decreased.
E