Yamaha Waverunner XLT1200 Wartungshandbuch Seite 418

– +
ELEC
INDICATION SYSTEM
Speed meter
1. Check:
Speed meter output voltage
Within specification → Check the speed
sensor output voltage and pulses.
Out of specification → Replace.
Speed meter output voltage:
10.5 V
Checking steps:
Supply DC 12 voltage to the natural
six-pin connector (+: red, –: black) with
a battery.
Disconnect the blue one-pin connector
1 and make sure the "WARNING" lamp
lights 2.
NOTE:
If the "WARNING" lamp does not light,
disconnect the battery and then recon-
nect it.
Measure the voltage on the speed
meter connector (white three-pin con-
nector) (between the red/white and
black leads).
7-45
E