Yamaha Waverunner XLT1200 Wartungshandbuch Seite 438

HULL
HOOD
a
HANDLEBAR
1
b
3. Install:
Throttle cable
NOTE:
Fit the seal into the groove in the bracket.
4. Adjust:
QSTS cable length a
QSTS cable length:
77 ± 0.5 mm (3.03 ± 0.02 in)
NOTE:
Before adjusting the QSTS cables, set the
trim grip to the neutral position.
Adjust the QSTS cable lengths a to the
specified length and be sure to take up
any slack.
5. Install:
Handlebar cover 1
NOTE:
When the handlebar cover is in contact with
the steering boss cover, adjust the handle-
bar mount angle so that the clearance a
and b are equal.
6. Adjust:
Throttle cable free play
Refer to "CONTROL SYSTEM" in
Chapter 3.
7. Adjust:
QSTS cable
Refer to "CONTROL SYSTEM" in
Chapter 3.
8-7
E