External Mileage Indicator - Otto Bock B 600 Bedienungsanleitung

Options
Other special controls such as LED-push button control, 5-button keyboard control,
Buddy-Button control and environment control are available in conjunction with the
LCD module.

12.13 External Mileage Indicator

As an optional extra you can have fitted to the protective bow of the control panel an
external mileage indicator, which includes a speedometer, a day's mileage indicator, a
total mileage indicator and a time indicator (fig. 39).
If the display shows m/h in the left upper corner, this means the speed indicator is
active.
Using the yellow button you can switch to the day's mileage indicator which shows
three flashing arrows on the left side of the display.
To reset the day's mileage indicator to zero, depress and hold the button for 3
seconds.
Shortly press the button again to display the total mileage indicator.
Press again to see the time display.
To set the time, depress and hold the button for 3 seconds.
12: and 24: will appear in alternating manner.
To activate the 24-hour display, press the button whilst the 24: is displayed, to activate
the 12-hour display, press the button whilst the 12: is displayed.
Now the time is displayed and the digits are automatically advanced one after the
other.
To set the time, depress the button until the desired digits are shown on the display.
When the total mileage indicator is active you can change between m/h and km/h by
pressing and holding the yellow button for 3 seconds. For the mileage measurement
the wheel circumference needs to be entered here.
To calculate the wheel circumference use the following formula:
90
Attention!
When a special control is used, the healthcare provider must
instruct the user in detail on how to use the control!
Fig. 39: Mileage indicator
B600 – Instructions for Use