Changing The Fuse; Changing Tyres/Inner Tube; Fig. 30 Battery Pack With Fuse - Otto Bock A200 Gebrauchsanweisung

9.2 Changing the Fuse
The fuses (for values see section „Technical Data" > table
„Electric equipment") are located respectively in one of the
fuse holders on the bottom of the battery packs (see Fig. 30).
1. Remove the batteries (see section 6.5).
2. Simply pull out the fuse on the underside.
3. Insert the new fuse between the contacts into the fuse
holder on the battery underside. Make sure that the fuse
is pressed into the centre of the spring contacts and
that it is not at an angle.
4. Reinstall the batteries (see section 6.5).
Fig. 30 Battery pack with fuse
A200
9.3 Changing Tyres/Inner Tube
INFORMATION
Direct sunlight (UV light) causes the tyres to age prematu-
rely. As a result, the tread surface hardens and corner pie-
ces break out of the tread.
INFORMATION
Avoid parking the wheelchair outdoors whenever possible.
Regardless of wear and tear, the tyres should be replaced
every 2 years.
If the wheelchair is parked for an extended period of time
or the tyres overheat (e.g. in the vicinity of radiators or in
case of exposure to strong sunlight behind glass), the tyres
may become permanently deformed. Therefore, sufficient
clearance should always be maintained from sources of
heat, and the wheelchair should be moved frequently or
placed on blocks for storage.
To change the tyre/inner tube of a drive wheel, proceed as
follows:
1. Secure the wheelchair to prevent it from tilting to the
side by placing a suitable base under the drive unit sus-
tainer.
Maintenance, Cleaning and Care
Ottobock
|
129