Save Configuration Parameters (Sns); Set Configuration Parameters To Factory Default (Snd); Get Software Version (Snsv) - TR-Electronic _LLB500(F)-00601 Benutzerhandbuch

10.3.8 Save configuration parameters (sNs)

This command saves all configuration parameters, which are set by the commands above. The
parameters are written to the flash memory.
Command
Return successful gNs?<trm>
Return Error
Parameters

10.3.9 Set configuration parameters to factory default (sNd)

This command restores all configuration parameters to their factory default values. The parameters
are written to the Flash Memory and therefore permanently saved.
The communication parameters are also reset to factory settings.
Command
Return successful gN?<trm>
Return Error
Parameters

10.3.10 Get Software Version (sNsv)

Retrieve the software version of the LLB measuring system.
Command
Return successful gNsv
Return Error
Parameters
Printed in the Federal Republic of Germany
03/09/2016
Command
sNs<trm>
gN@Ezzz<trm>
Device ID (0..9)
N
Error code
zzz
Command
sNd<trm>
gN@Ezzz<trm>
Device ID (0..9)
N
Error code
zzz
Command
sNsv<trm>
+xxxxyyyy<trm>
gN@Ezzz<trm>
Device ID (0..9)
N
Internal measuring device software version number
xxxx
Interface software version
yyyy
Error code
zzz
TR - ELE - BA - DGB - 0021 - 06
 TR-Electronic GmbH 2011, All Rights Reserved
Page 145 of 156