Set/Get User Distance Gain (Snuga); User Output Protocol (Snuo) - TR-Electronic _LLB500(F)-00601 Benutzerhandbuch

10.5.3 Set/Get user distance gain (sNuga)

The user can set an individual user gain to create user defined output values. The output value is
calculated as follows (see chapter 5.5.1 "Offset / Gain" on page 111).
Command
Return successful gNuga?<trm>
Return Error
Parameters
Configuration parameters must be saved (see 10.3.8 "Save configuration parameters (sNs)" on page 145).

10.5.4 User output protocol (sNuo)

This command modifies the output for the user configured commands. The output can be configured
to fit the requirement of an external display.
A parameter for the output mode between 100 and 189 defines the format for an external display. The
last digit of the parameter defines the field length for the output number. The output of a distance
measurement will be right aligned. The decimal point will be inserted at the position (counted from
right) defined by middle digit (See 5.5.2 "Output format" on page 111).
Command
Return successful gNuo?<trm>
Return Error
Parameters
Configuration parameters must be saved (see 10.3.8 "Save configuration parameters (sNs)" on page 145).
Printed in the Federal Republic of Germany
03/09/2016
Set Command
sNuga+xxxxxxxx+yyyyyyyy<trm> sNuga<trm>
<trm>
gN@Ezzz
Device ID (0..9)
N
GainNum
xxxxxxxx
GainDen
yyyyyyyy
GainDen
Error code
zzz
Set Command
sNuo+xxxxxxxx<trm>
<trm>
gN@Ezzz
Device ID (0..9)
N
Output Mode
xxxxxxxx
0:
1:
1ab: output formatted for external display
a ≤ b, if a = b, no decimal point is output.
Conditions:
Error code
zzz
TR - ELE - BA - DGB - 0021 - 06
gNuga+xxxxxxxx+yyyyyyyy<trm>
gN@Ezzz
User
User
must not be zero
User
sNuo<trm>
gNuo+xxxxxxxx<trm>
gN@Ezzz
display distance
display additional information
a: Number of digits after decimal point
b: Field with (sign included) must be greater than 0
Get Command
<trm>
Get Command
<trm>
 TR-Electronic GmbH 2011, All Rights Reserved
Page 153 of 156