Factory Settings; Standard Configuration; User Configured Measurement - TR-Electronic _LLB500(F)-00601 Benutzerhandbuch

Factory settings

9 Factory settings

9.1 Standard configuration

Operation Mode
Serial Communication
Analog outputs
SSI Output
only at LLB-500(F)
Device ID
Digital output 1 (DOUT1)
Digital output 2 (DOUT2)
Digital input 1 (DI1)

9.2 User configured measurement

User distance
offset and gain
Measurement characteristic
Measurement Filter
Output protocol
 TR-Electronic GmbH 2011, All Rights Reserved
Page 130 of 156
Controlled
Baud: 19200
Data bit: 7
Parity: even
Stop bit: 1
(Setting 7)
Min. output: 4 mA
Error output: 0 mA
Range min.: 0 m
Range max.: 10 m
Inactive (default is RS-422 active)
Replacement value in case of an error: 0
ID Number: 0
ON: 2 m + 5 mm = 2005 mm
OFF: 2 m – 5 mm = 1995 mm
ON: 1 m + 5 mm = 995 mm
OFF: 1 m – 5 mm = 1005 mm
Inactive, configured as output
User distance offset = 0 mm
User Gain Num =
Gain =
User Gain Den =
Normal
Inactive
No special configuration, display distance
TR - ELE - BA - DGB - 0021 - 06
GainNum 1000
User
=
1000
GainDen
User
Printed in the Federal Republic of Germany
1000
=1
1000
03/09/2016