Rs-232 Serial Interfaces; Rs-422 Serial Interface - TR-Electronic _LLB500(F)-00601 Benutzerhandbuch

8.6 RS-232 serial interfaces

The RS-232 interface is used for device configuration. It is made to connect the measuring system to
a PC to do the configuration either by terminal program or by the LLB-Utility software, see chapter 5.1
"Connection for device configuration" on page 101.
If the Moving Target measurement characteristic is active, a measurement speed of
250 Hz is only possible if the baud rate is set to 115200. Lower baud rates reduce the
measurement speed

8.7 RS-422 serial interface

The RS-422 interface is made for industrial communication and therefore long cables (twisted pair) are
supported. This interface is thought to use the LLB measuring system in controlled mode.
If the Moving Target measurement characteristic is active, a measurement speed of 250
Hz is only possible if the baud rate is set to 115200. Lower baud rates reduce the
measurement speed
Printed in the Federal Republic of Germany
03/09/2016
• Danger of physical injury and damage to property by undefined
interface states !
The RS-422 interface cannot be used simultaneous with the SSI interface.
-
TR - ELE - BA - DGB - 0021 - 06
 TR-Electronic GmbH 2011, All Rights Reserved
Page 127 of 156