10 Command set
10.1 General
All commands must be entered about a terminal program.
10.1.1 Command termination <trm>
All commands for the LLB are ASCII based and terminated
10.1.2 Device identification
Since the device can be addressed with the ID switch, the ID is represented in the commands by
the location of the
N
insert the Device ID.
10.1.3 Parameter separator
The command syntax uses the plus sign '+' as parameter separator. The '+' can be replaced by the
minus sign '-' if applicable by the command.
10.1.4 Set/Get commands
All configuration commands that are used to set configuration values can also be used to read the
currently set value by omitting the parameter. The command syntax is described as follows:
Command
Return successful gNuof?<trm>
Return Error
Parameters
10.1.5 Startup sequence
After power on the LLB does all the initializations and sends a start sequence
the
N
stands for the Device ID. After sending this start sequence, the LLB measuring system is ready
to use.
Printed in the Federal Republic of Germany
03/09/2016
N
Set Command
sNuof+xxxxxxxx<trm>
<trm>
gN@Ezzz
Device ID (0..9)
N
Offset in 1/10 mm; + positive / - negative
xxxxxxxx
Error code
zzz
TR - ELE - BA - DGB - 0021 - 06
<trm>
with
<cr><lf>.
Get Command
sNuof<trm>
gNuof+xxxxxxxx<trm>
<trm>
gN@Ezzz
gN?
TR-Electronic GmbH 2011, All Rights Reserved
. At
N
. On this sequence,
Page 131 of 156